The Linear Non contact hall’s effect Displacement transducer is used to detect the displacement of system which correspondence to the Linear motion of the shaft of the sensor.- The Output signal correspondence to 0 to 10mm. Customization in the stroke length is possible. Since the Product is based on Contactless Magnetic
- Technology it has very long life, along with high vibration withstand capacity.
- Linear Hall effect transducer is a economical product with highly good accuracy and resolution of 12bit over a full range.
- The USP of the sensor being Extremely compact in size and complete metal housing with IP protection class upto Ip67 .
- Technical
- Mechanical
- Electrical
Technical
Magnetic Cross Talk
If two LHS units are to be installed closer than 2 inch (measured between the center of both shaft), a magnetic shield, such as a small steel plate should be installed in between to prevent one from long with that a sensor from causing small changes in reported position through magnetic field cross talk.
Material
| Component | Material |
| Housing | Brass |
| Shaft | Stainless |
Temperature
| Parameter | Value |
| Operating Temperature | -40 to 75 deg (standard) -40 to 140 deg ( on request) |
| Storage Temperature | -40 to 75 degC |
Ordering Information
Mechanical
| Parameters | Range |
| Starting force | |
| Maximul Radial Load | 1Kg. |
| Maximum Shaft Speed | 100 Shaft Stroke / min |
| Bearing Life cycles | 200 X 10^6 @rated radial Load |
| Weight of sensor | |
| Shaft Dia | 4mm |
Electrical
- Electircal Analog Output
- PWM O/P
Electircal Analog Output
| Parameters | Results |
|---|---|
| Supply Voltage (Vsupply) | 5Vdc(+/- 10%) |
| Supply Current | 20mA |
| Response time | 50mS |
| Resolution | 12bit @ full stroke |
| Load Resistance | Minimum 10k ohms (preferred >100k ohms) |
| Output (Voutput) | 10% to 90% Vsupply (Ratiomatric) @ 5V supply |
| Electrical Travel | 10mm standard. (other on request maximum 20mm) |
| Mechanical Travel | 12mm standard. (other on request maximum 22mm) |
| Linearity | 1% Independent Linearity ( Available 0.5% on request) |
Signal Converter cards are available for 0 to 10Vdc, 4 to 20mA or any other digital communication protocol based on requirement.
PWM O/P
| Parameter | Results |
|---|---|
| Supply Voltage (Vsupply) | 5Vdc (+/- 10%) |
| Supply Current | 20mA |
| Frequency | 200Hz, 500Hz, 1K Hz or 2 Khz based on requirement |
| Resolution | 12bit |
| Output (Voutput) | 0% to 90% duty Cycle |
| Linearity | 1% Independent Linearity ( Available 0.5% on request) |